Let's look at how to disassemble a microwave door :

[shapanwwuom]

Then remove the interference suppression filter by disconnecting the power harnesses from it and removing the fastener that secures the ground wire to the back wall. Press on the two plastic latches and remove it. After that, disconnect the power harnesses from the tank, unscrew the screw, and secure the ground wire of the high-voltage diode. At the next stage, disconnect the harnesses from the current relay and the fan. Remove the fasteners and remove the fan.

If you need to get the backlight lamp , disconnect the wires from it and remove the fasteners that secure the air duct to the magnetron. Press the latches of the air duct to remove the indicator panel.

Note: To remove parts from a microwave oven, follow the same principle: disconnect the wires, remove the fasteners, and remove the part.

The equipment is assembled in the reverse order . To simplify japan telegram data the process, it is better to record the disassembly of the device on camera or take photos. When assembling the microwave oven, act very carefully so as not to damage it and not cause a leak of microwave radiation.

Disassembling the microwave door
It happens that microwave malfunctions occur because of the door. Regardless of the model, the designs have many common points . Doors have a layered structure, which includes a supporting (metal), protective and outer (decorative) layer. They differ from each other in the number of layers, the material of manufacture and the method of fastening.


First, prepare the tools: a knife and 2 screwdrivers with a wide flat blade.
The process begins with detaching the seal frame.
Then the outer frame, which is fixed with screws or latches, is separated.
If the door needed to be cleaned of dirt, this completes the disassembly process.
At the next stage, carefully, so as not to break it, separate the glass from the plastic trim.
When necessary, the film, which is attached to a metal base, is removed from the inside of the door.